Skip to content
Gas furnace and water heater in a home basement
Assurance HVAC Heating & Cooling, serving Ajax

Furnace repair in Ajax

(647) 692-0819Open 24/7, day or night

Furnace repair in Ajax starts with finding the real fault, not swapping parts and hoping. Assurance HVAC Heating & Cooling sends TSSA-certified gas technicians to homes across Ajax, from Pickering Village to Westney Heights. As your HVAC contractor in Ajax, we test first, explain what failed, and give you a flat-rate price to approve before any work begins.

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add email, details or text updatesOptional

Or call (647) 692-0819Used only to book your visit. Privacy

Key takeaways

  • TSSA-certified gas technicians repair every major brand of furnace across Ajax.
  • We find the fault first, then quote a flat-rate price you approve.
  • Every repair carries a written workmanship warranty.
  • Booked visits get a two-hour arrival window with a text before we arrive.
  • No heat at night? Emergency calls are answered 24/7.

Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.

On this page
  1. How to tell your Ajax furnace needs repair
  2. Furnace won’t turn on: checks you can do first
  3. Furnace not heating enough in Ajax homes
  4. Common furnace repair in Ajax: the parts that fail most
  5. Furnace blower problems: noise, weak airflow and constant running
  6. How furnace repair in Ajax works, visit by visit
  7. Repair or replace your furnace?
  8. Furnace repair in Ajax: what you pay and why
  9. Serving furnace owners from Pickering Village to Duffins Bay
  10. Furnace brands we repair
  11. Furnace safety: gas smell and carbon monoxide
  12. Preventing the next breakdown
  13. No heat at night? Call anyway
  14. Furnace repair questions from Ajax homeowners

How to tell your Ajax furnace needs repair

A furnace that is not heating, blows cold air, short cycles, makes new noises or runs without warming the house needs a technician. Catching a fault early in any Ajax home usually means a smaller repair, and a few warning signs show up well before a complete shutdown.

  • The furnace runs but the air from the registers stays cool or lukewarm.
  • It starts and stops every few minutes instead of finishing a heating cycle.
  • You hear banging, squealing, rattling or a loud hum from the cabinet.
  • Some rooms stay cold while others get too warm.
  • The pilot or burner will not light, or the flame looks uneven.
  • Heating bills rise with no change in how you use the house.

Never ignore a smell of gas or a carbon monoxide alarm. Those are safety calls, covered further down this page.

Furnace won’t turn on: checks you can do first

If your furnace will not start, a few safe checks can save a visit. Confirm the thermostat is set to Heat with a setpoint above the room temperature, then check the breaker and the furnace’s service switch. Any of those three can stop a furnace from starting.

Next, look at the filter. A clogged filter restricts airflow and can trip the high limit switch. Make sure every register and return in the house is open. If the furnace has a condensate drain, look for water backed up in the trap or line.

Reset a tripped breaker only once. If it trips again, leave it off and call us. Never open sealed burner or electrical compartments, and do not bypass any safety switch.

Furnace not heating enough in Ajax homes

When a furnace runs but does not heat well, the cause is usually airflow, ignition or a part that has worn out. A dirty filter, a failing blower motor or a flame sensor coated with residue can all leave the house cool even though the furnace sounds normal.

Ajax homes were built in waves, from wartime houses to 1970s streets in central Ajax and early 1980s homes in Westney Heights, and many have been renovated since, so we don’t assume what the ducts look like. Rooms that never warm up may point to a duct or return problem rather than the furnace itself, and we check both.

If a house has been renovated or added onto, the original furnace and ducts may not cover the new space well. Our technicians can tell you whether a repair, a duct change or a different system makes sense.

Common furnace repair in Ajax: the parts that fail most

Most furnace repairs involve a short list of parts. Knowing which one failed matters, because each has a different cause, and replacing the wrong one wastes money. Our gas technicians test the part, show you the reading and explain the options before quoting.

Lighting faults: flame sensor and igniter

A flame sensor that is dirty tells the control board the burner is not lit, so the furnace shuts down after a few seconds. A hot surface igniter that is cracked or weak will not light the gas at all. Both are routine repairs.

Draft faults: inducer motor and pressure switch

The inducer motor pulls exhaust out and proves airflow through the pressure switch. A worn motor or a stuck switch stops the furnace before it lights, often with a humming or rattling sound.

Blower motor and ECM blower

The blower pushes warm air through the ducts. A failing motor, a bad capacitor or a faulty ECM module leaves you with weak airflow, noise or a furnace that overheats and trips the limit switch.

Control board, limit switch and condensate drain

A failing control board or a tripped limit switch can lock the furnace out. On high-efficiency models, a blocked condensate trap or drain line can also shut the furnace down.

Furnace blower problems: noise, weak airflow and constant running

A blower that squeals, rattles, runs constantly or barely moves air is a repair call. The cause is often a worn motor bearing, a dirty blower wheel, a failed run capacitor or a clogged filter, and each one needs a different fix.

If the fan runs all the time, check whether the thermostat fan setting is on Auto. If it is, a technician should look at the control board and the limit circuit. Do not remove panels to look inside the blower compartment yourself.

How furnace repair in Ajax works, visit by visit

A repair visit follows the same steps every time: we listen to what the furnace has been doing, test it through a full heating cycle, find the cause, and show you what we found. Only then do we give you a flat-rate price to approve.

  • We confirm the symptoms and check the thermostat, filter and power supply.
  • We run the furnace through its start-up sequence and watch each stage.
  • We test the failed part and the parts around it, including venting and drains.
  • You get one flat-rate price. Nothing starts until you approve it.
  • After the repair, we run the furnace again and confirm it heats properly.

Every repair is covered by our written workmanship warranty. Booked visits get a two-hour arrival window, and we text you before we arrive.

Repair or replace your furnace?

Repair makes sense when the furnace is within its typical 15 to 20 year lifespan and the fault is a single part. Replacement is worth pricing when the furnace is near the end of that range, has a cracked heat exchanger, or keeps failing.

How to weigh repairing against replacing a gas furnace
SituationUsually betterWhy
Under about 12 years old, one failed partRepairThe rest of the furnace has life left
15 to 20 years old, major part failedCompare bothA large repair on an old furnace is a poor bet
Cracked heat exchangerReplaceIt is a safety issue and is not a practical repair
Third repair in a few seasonsReplaceRepeat faults signal general wear
Old, low-efficiency furnace and high billsReplaceA condensing furnace is 90% AFUE or better

If replacement is the better call, see our page on furnace installation in Ajax for sizing and efficiency options.

Furnace repair in Ajax: what you pay and why

The price of furnace repair in Ajax depends on the part that failed, the furnace’s age and brand, and how easy it is to reach. We do not guess by phone. A technician finds the fault first, then gives you a flat-rate price you approve before the work starts.

What changes the cost of a furnace repair
FactorHow it affects the cost
Which part failedA flame sensor is a small job. A control board or blower motor is bigger.
Age and brandParts for older or less common models can take longer to source.
AccessA tight mechanical room or finished ceiling adds labour.
Parts on handA part on the truck means a same-visit repair; one that must be ordered takes longer.
Related workA blocked drain or damaged venting may need attention at the same time.

Serving furnace owners from Pickering Village to Duffins Bay

Our technicians go to every part of Ajax, including Pickering Village, Pickering Beach, Downtown, Midtown, Westney Heights, Applecroft, Audley North, Clover Ridge, Duffins Bay, Lakeside, Nottingham and Salem Heights. We have no Ajax storefront, so each visit starts with a technician coming to you.

Pickering Village is the oldest settled centre in Ajax and a historic neighbourhood. In older homes we talk through where venting and equipment sit before quoting. The Town of Ajax (opens in a new tab) website has local information for homeowners.

Furnace brands we repair

We service all major brands of furnace. A technician’s job is to diagnose the unit in front of them, whatever the badge, and explain the fault and the options in plain language. If a part is hard to find, we tell you before you decide.

Have the model and serial number ready when you call if you can find them on the rating plate inside the furnace door. It is helpful, but not required to book a visit.

Furnace safety: gas smell and carbon monoxide

If you smell gas, leave the house at once without touching light switches or phones, and call Enbridge Gas at 1-866-763-5427 from outside. If a carbon monoxide alarm sounds, get everyone outdoors and call 911.

Ontario’s rules call for a carbon monoxide alarm beside every sleeping area, plus one on every storey since January 1, 2026, in Ajax homes with a fuel-burning appliance, a fireplace or an attached garage. Test yours regularly and replace them as the maker directs. The Ontario CO safety page (opens in a new tab) explains where alarms should go.

Preventing the next breakdown

Most furnace failures build slowly, so a yearly tune-up and regular filter changes prevent many of them. A tune-up cleans and tests the parts that wear, and it is the easiest way to avoid a no-heat call in the coldest weeks.

Our maintenance plan includes two tune-ups a year and priority booking. Many manufacturer warranties ask for proof of regular maintenance, so check your warranty papers. Ontario does not require yearly furnace maintenance by law.

No heat at night? Call anyway

We are open 24/7, and technicians go out day or night, weekends included. If the furnace has stopped and the house is getting cold, call us. Emergency calls go to the front of the line, and we do not promise arrival times on emergencies.

For what to do while you wait and how emergency calls work, see our page on emergency furnace repair in Ajax.

FAQ

Furnace repair questions from Ajax homeowners

Who does furnace repair in Ajax?

Call the main line or send the request form, and we send a TSSA-certified gas technician to your home anywhere in Ajax. Technicians come to you, so the repair happens at your house. Booked visits get a two-hour arrival window, and we text you before the technician arrives.

Why is my furnace running but not heating?

Common causes are a dirty filter, a flame sensor coated with residue, a weak blower motor or a failed igniter. Check the thermostat is on Heat and the filter is clean. If the air is still cool, call us and we will test the furnace through a full cycle.

What should I check if my furnace won’t turn on?

Check the thermostat mode and setpoint, the breaker and the furnace service switch, and replace a dirty filter. Make sure registers are open. Reset a tripped breaker only once. If it trips again or nothing changes, leave it off and book a repair visit.

How much does furnace repair cost in Ajax?

The price depends on the part, the furnace and the access. A technician diagnoses the fault first, then gives you one flat-rate price. You approve it before work starts, so there are no surprises, and the repair is covered by our written workmanship warranty.

Can you repair my furnace the same day?

We book a two-hour arrival window and text you before we arrive. Many repairs are finished on the first visit when the part is on the truck, but we can’t promise that for every fault. If a part must be ordered, we tell you before you decide.

Is it worth repairing an old furnace?

It depends on age and the fault. Gas furnaces typically last 15 to 20 years. A small repair on a furnace in the middle of that range is usually worth it. A cracked heat exchanger or a third repair in a few seasons points to replacement.

Will you work on my furnace whatever the brand?

We service all major brands. Our technicians diagnose the unit in front of them, whatever the brand, and explain the fault and the options plainly. If you can, have the model number from the rating plate ready, though it is not required to book.

What do I do if I smell gas or my CO alarm goes off?

If you smell gas, leave the house, avoid switches and phones inside, and call Enbridge Gas at 1-866-763-5427 from outside. If a carbon monoxide alarm sounds, get everyone outside and call 911. Do not go back in until it is safe.

Book a visit

Need furnace repair in Ajax? We’ll call you back to book.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

(647) 692-0819

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add an email or detailsOptional

Or call (647) 692-0819Used only to book your visit. Privacy