
Furnace installation in Ajax
(647) 692-0819Open 24/7, day or night
Furnace installation in Ajax is more than swapping a box: the right size, venting and efficiency decide how the house feels for the next 15 to 20 years. Assurance HVAC Heating & Cooling sends TSSA-certified gas technicians across Ajax to replace furnaces, sized by a heat-loss calculation. Not sure it is time? Start with furnace repair in Ajax.
Key takeaways
- We size every new furnace with a heat-loss calculation, not the old nameplate.
- Condensing models are 90% AFUE or better; we explain two-stage and modulating options.
- We handle the permits and inspections the job needs.
- You get a flat-rate price to approve before work starts, and a written warranty.
- Cold-climate heat pumps are an alternative; see rebates for details.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.
On this page
- Signs you need furnace installation in Ajax
- Furnaces for Ajax homes built in different eras
- Sizing furnace installation in Ajax: the heat-loss calculation
- High-efficiency furnaces: AFUE and what it means
- Single-stage, two-stage and modulating furnaces
- Checks on venting, drains and ducts before we install
- Furnace installation in Ajax: how the day unfolds
- Hybrid heat: a furnace paired with a heat pump
- What shapes the price of furnace installation in Ajax?
- Keeping a new furnace running well
- Installing furnaces from Pickering Village to Southwood
- Planning ahead so you are not replacing in an emergency
- Which furnace brand should I choose?
- Furnace installation questions from Ajax homeowners
Signs you need furnace installation in Ajax
A gas furnace in an Ajax home typically lasts 15 to 20 years, so age is the first signal. Repeated repairs, rising heating bills, uneven rooms, a noisy or short-cycling furnace and a cracked heat exchanger are the others. Any one of them is a reason to price a replacement.
- The furnace is 15 years old or more and needs a major part.
- A technician finds a cracked heat exchanger.
- Repairs have come back several times in a few seasons.
- Some rooms never get comfortable, and the furnace runs constantly.
- Heating bills keep rising with no change in how you live.
A cracked heat exchanger is a safety issue, and the furnace stays off. If you smell gas, leave and call Enbridge Gas at 1-866-763-5427 from outside. If a carbon monoxide alarm sounds, get everyone outside and call 911.
Furnaces for Ajax homes built in different eras
Ajax grew from a wartime community with pre-fabricated houses, to post-war subdivisions from 1947, to new streets across central Ajax in the 1970s, to Westney Heights in the early 1980s. A replacement that suits one era may not suit another, so we look at the house instead of working from a formula.
In an older house, we check the ductwork, return air and venting before recommending a unit. Renovations and additions can change how much heat a house needs. In a large multi-level house, such as the upscale homes built along Lake Driveway in the early 1980s, we check whether one furnace can serve every level or whether zoning or staging makes sense.
Newer buildings near Downtown and Pat Bayly Square, and Midtown and Applecroft homes, have their own layouts, so we measure each one.
Pickering Village is the oldest settled centre in Ajax, and Pickering Beach began as a cottage community in 1926. Both are older parts of town, so we go over the equipment, venting and options on site before quoting. The same care applies to every neighbourhood in Ajax.
Sizing furnace installation in Ajax: the heat-loss calculation
The right furnace size comes from a room-by-room heat-loss calculation, not from the old furnace’s label. Homes change after a furnace goes in: new windows, added insulation and finished basements all change the load. An oversized furnace short cycles, and an undersized one never catches up.
We measure the house, account for its insulation and windows, and pick a capacity to match. We also check that the ducts can move the air the new furnace will produce.
High-efficiency furnaces: AFUE and what it means
AFUE is the share of fuel a furnace turns into heat for your home. A condensing furnace is 90% AFUE or better, which means less fuel is lost up the vent. Higher efficiency usually costs more up front and less to run.
Condensing furnaces use plastic venting and a condensate drain, so installation includes drain routing. Older mid-efficiency furnaces vent through a chimney. We explain what changes if you switch, including any impact on a water heater that shares the flue.
Single-stage, two-stage and modulating furnaces
Single-stage furnaces run at full output only. Two-stage models have a low and a high setting, and modulating furnaces adjust output in small steps. More stages mean steadier temperatures, fewer cold spots and quieter running.
| Type | How it runs | Best for |
|---|---|---|
| Single-stage | Full output only | Smaller homes and simpler budgets |
| Two-stage | Low setting most of the time, high on cold days | Most homes; steadier comfort |
| Modulating | Adjusts output in small steps | Larger or multi-level homes; best comfort |
Pairing a two-stage or modulating furnace with a variable-speed ECM blower evens out airflow and cuts blower noise.
Checks on venting, drains and ducts before we install
Before we install, we check what the new furnace needs: a safe vent path, a drain for condensate and ducts that can carry the airflow. Skipping these checks is how new furnaces end up noisy or short cycling.
Vent path and combustion air
A condensing furnace vents through plastic pipe to the outside. We choose the route, keep it clear of snow and ice, and make sure the furnace gets the combustion air it needs.
Where the condensate goes
Condensing furnaces produce water that must drain properly. We route it to a floor drain or install a condensate pump if needed.
Supply ducts and return air
We check that the supply and return ducts are the right size and sealed. Undersized returns are a common reason a new furnace does not feel better than the old one.
Furnace installation in Ajax: how the day unfolds
On installation day, our TSSA-certified gas technicians protect your floors, disconnect and remove the old furnace, set the new one, connect gas, venting, drain and electrical, then commission it. We handle the permits and inspections the job needs.
- We cover floors and clear a path to the mechanical room.
- The old furnace is disconnected and removed.
- The new furnace is set, with venting, condensate and gas connected.
- We test combustion, airflow and safety controls.
- We walk you through the thermostat and filter, and clean up.
We do not promise a fixed number of hours, since each house differs, but we tell you what to expect at the quote.
Hybrid heat: a furnace paired with a heat pump
A cold-climate heat pump can work alongside a new furnace, handling most heating on mild days and cooling in summer, with the furnace taking over on the coldest ones. It is worth pricing if your air conditioner is also near the end of its life.
Rebates, where available, are limited to certain programs. Check the rebates page for what is open, since amounts depend on the home and current heating fuel.
What shapes the price of furnace installation in Ajax?
The cost of a new furnace in Ajax depends on its efficiency and stages, the size of the house, and the venting, duct and electrical work involved. We measure first, then give you one flat-rate price you approve before any work starts.
| Factor | Why it matters |
|---|---|
| Efficiency and stages | Modulating and high-AFUE models cost more up front and less to run. |
| Home size | A larger or multi-level home needs a bigger or more capable furnace. |
| Venting | Moving off a chimney to plastic venting adds work. |
| Ductwork | Undersized returns or leaky ducts may need fixing. |
| Extras | Humidifiers, filters and thermostats add to the scope. |
Keeping a new furnace running well
A new furnace in Ajax lasts longer when it is looked after. Change the filter on schedule, keep the vent and intake clear of snow, and book a yearly tune-up. Many manufacturer warranties ask for proof of regular maintenance, so check your warranty papers.
Our maintenance plan includes two tune-ups a year and priority booking. Ontario does not require yearly furnace maintenance by law, but it helps catch small faults early.
Installing furnaces from Pickering Village to Southwood
Our technicians install furnaces across Ajax, including Pickering Village, Pickering Beach, Westney Heights, Audley North, Clover Ridge, Duffins Bay, Lakeside, Nottingham, Salem Heights and Southwood. We have no Ajax storefront, so we come to you for a quote. Our HVAC contractor in Ajax page covers the rest of our services across the town.
If your home sits near Markham or Toronto, you may also want to see our Markham furnace installation page. The Town of Ajax (opens in a new tab) website has local information.
Planning ahead so you are not replacing in an emergency
The best time to replace a furnace is before it fails. A planned installation lets you compare options, choose a model that suits the house and book a day that works for you, instead of deciding in a cold house at night.
If your furnace is past 15 years, keep an eye on warning signs: new noises, more frequent repairs and uneven rooms. A technician can assess the furnace during a tune-up and tell you honestly how much life it has left.
If the furnace fails before you are ready, our team can still help. See our page on emergency furnace repair for how after-hours calls work, and we will talk through repair and replacement options once the heat is back on.
Which furnace brand should I choose?
We service all major brands, and the right choice depends on the model, the install and your budget more than the badge. We recommend equipment that fits the house and explain the trade-offs between efficiency, stages and blower type.
Furnace installation questions from Ajax homeowners
How many years should a new furnace give me?
A gas furnace typically lasts 15 to 20 years, depending on the model, how well it was installed and whether it has been maintained. If yours is in that range and needs a major repair, it is worth pricing a replacement alongside the fix.
How do you size a new furnace?
We run a heat-loss calculation for the house, room by room, instead of copying the old furnace’s size. It accounts for insulation, windows and layout. A furnace that is too big short cycles, and one that is too small never catches up.
What is AFUE, and what should I choose?
AFUE shows how much of a furnace’s fuel becomes heat for your home. Condensing furnaces are 90% AFUE or better. Higher efficiency costs more up front and less to run, and we explain the venting and drain changes involved before you decide.
Do you handle permits and inspections?
Yes. We handle the permits and inspections the job needs, so you do not have to chase them. Your technician explains what is involved when they quote the work, and the written workmanship warranty covers the installation once it is finished and tested.
How long does installation take?
It depends on the house, the venting and any duct changes, so we do not promise a fixed number of hours. A technician looks at the job first and tells you what to expect, including whether any extra work is needed.
Can I pair a new furnace with a heat pump?
Yes. A cold-climate heat pump can handle much of the heating and cooling, with the furnace as backup on the coldest days. It is worth considering if your AC is old. See the rebates page for what programs are open.
What does a furnace installation cost in Ajax?
It depends on the furnace’s efficiency and stages, the size of the house, and any venting, duct or electrical work. A technician measures first, then you get one flat-rate price. You approve it before any work starts, and we explain what each line covers.
Do I need to maintain a new furnace?
Ontario does not require yearly furnace maintenance by law, but a yearly tune-up helps it last. Many manufacturer warranties ask for proof of regular maintenance, so check your warranty papers. Our maintenance plan includes two tune-ups a year and priority booking.
Need furnace installation in Ajax? We’ll call you back to book.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
