Skip to content
Outdoor heat pump unit beside a brick house
Assurance HVAC Heating & Cooling of Markham

Heat pump installation in Markham

(647) 496-5598Open 24/7, day or night

From builder-grade 1990s and 2000s homes in Berczy Village, Greensborough and Box Grove to heritage houses in Unionville and Markham Village and townhomes in Cornell, Assurance HVAC Heating & Cooling of Markham matches each heat pump installation in Markham to the house it goes into. We size each cold-climate or ductless system room by room, confirm what the ducts, panel and outdoor space allow, and quote one flat price you approve before work starts. See our heating and cooling services in Markham for everything else we do.

Get an installation quote

Tell us about your home. We’ll call to book a quote visit.

What do you need?
How soon? Optional
Add email, details or text updatesOptional

Or call (647) 496-5598Used only to book your visit. Privacy

Key takeaways

  • Heat pumps for every kind of Markham home, from heritage houses to new townhomes.
  • A room-by-room heat-loss calculation sets the size, not the old air conditioner’s nameplate.
  • Refrigerant handled by 313A-certified mechanics, with WSIB coverage and full insurance.
  • You approve one flat-rate price first, and a written workmanship warranty follows.
  • Rebate eligibility checked against the Home Renovation Savings Program before you buy.

Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling of Markham service team.

On this page
  1. Heat pump installation in Markham when an R-22 air conditioner fails
  2. From builder-grade cooling to a cold-climate heat pump
  3. Ducted and ductless options compared for Markham houses
  4. Ductless heat pumps for heritage houses in Unionville and Markham Village
  5. Rear lanes and compact yards in Cornell
  6. Few upstairs returns in Milliken and Thornhill
  7. Room-by-room sizing for heat pump installation in Markham
  8. A dual-fuel partner for a good high-efficiency furnace
  9. How cold is too cold for a heat pump?
  10. Efficiency numbers on a heat pump quote
  11. Ontario heat pump rebates and Markham eligibility
  12. Heat pump installation in Markham, from first visit to first heat
  13. Keeping it running: heat pump service and repair
  14. What sets the price of a heat pump in Markham?
  15. Heat pump installation questions from Markham homeowners

Heat pump installation in Markham when an R-22 air conditioner fails

Many air conditioners that went in with Markham’s late-1990s subdivisions use R-22, and that refrigerant is no longer produced. Once one springs a leak or loses its compressor, recharging it gets harder to justify, and that is the natural moment to price a heat pump instead of another air conditioner.

A heat pump uses the same outdoor spot and the same ducts as the AC it replaces. The difference is a reversing valve, which lets it run backwards in cold weather and move heat from the outdoor air into the house for much of the winter.

From builder-grade cooling to a cold-climate heat pump

The builder-grade systems in Berczy Village, Greensborough, Wismer and Box Grove were often sized by rule of thumb when the streets went up. A cold-climate heat pump is a chance to fix that: it is sized for the house as it is now and runs at variable speed, so it spends most of its time at low, quiet output.

Cold-climate models keep producing heat into the minus 20s, with output falling as the temperature drops. Heat from the registers feels warm rather than hot, and cycles are long and steady. In winter the outdoor unit defrosts itself now and then, and any vapour you see is normal.

Ducted and ductless options compared for Markham houses

A ducted heat pump is the usual choice for a two-storey home with a furnace and working ducts. A ductless mini-split is the usual choice where there are no ducts, the ducts can’t reach, or a room needs its own control, such as a heritage home on radiators or a room over the garage.

Comparing ducted and ductless heat pumps in Markham
DetailDuctedDuctless
Best matchSubdivision homes with a furnaceHeritage homes, radiators, rooms over the garage
Indoor sideA coil on the furnace or a compact air handlerWall, ceiling or floor heads, one per zone
Heating backupThe gas furnace, set up as dual fuelRadiators, baseboards, or none in mild months
Seen outsideOne outdoor unit and its line setOne or more outdoor units and covered line sets

Ductless heat pumps for heritage houses in Unionville and Markham Village

Older and heritage homes in Unionville and Markham Village often have tight basements, older ductwork never meant for central air and, in some cases, cast iron radiators. Ductless heads add cooling and efficient spring and fall heating there without new ducts, while the existing heat carries the coldest weeks.

Parts of these villages are heritage conservation districts, so equipment that can be seen from the street may need the city’s approval. Before we fix the spot for an outdoor unit or a line set cover on a front or side wall, check with the City of Markham (opens in a new tab) about what applies to your property.

Rear lanes and compact yards in Cornell

Many Cornell homes have rear lanes and compact yards, so the outdoor unit’s spot takes planning. It needs airflow, clearance for service, a raised base above the snow and somewhere for defrost water to drain away from paths and the lane.

Wall brackets or a slim side-yard location can both work, and we keep neighbours’ windows and patios in mind. In Cornell and Markham Centre townhomes and condos, we review any corporation rules on condensers and wall openings before quoting.

Few upstairs returns in Milliken and Thornhill

Milliken and much of Thornhill went up between the 1960s and the 80s, and many homes there are on a later furnace but still use the first set of ducts, with upstairs returns in short supply. A ducted heat pump depends on airflow, so return air is the first thing we check before choosing capacity.

Where returns are short, the fix may be an added return in a bedroom hallway, balancing dampers or a ductless head for the upper floor. A variable-speed indoor blower also helps by moving air gently through the whole cycle rather than in blasts.

Room-by-room sizing for heat pump installation in Markham

We size each heat pump from a room-by-room heat-loss calculation, using the walls, windows, insulation and air leakage of every room. That gives the capacity the house needs on a design-cold night and how much air each room should get, which matters far more for heating than an AC’s nameplate ever did.

Large two-storeys in Angus Glen and Cachet and compact townhomes in Cornell can need very different equipment, even where the old Markham air conditioners were the same size.

A dual-fuel partner for a good high-efficiency furnace

A dual-fuel system keeps your high-efficiency gas furnace and adds a heat pump on the same ductwork. The heat pump cools and does most of the heating, and the controls switch to the furnace when it gets cold enough that gas heat makes more sense. If the furnace is sound, it stays.

The new coil relies on the furnace blower, so we check its airflow, and we look at the electrical panel, since the heat pump needs its own circuit. If the furnace is giving trouble, book furnace repair in Markham first to learn whether it is worth keeping.

How cold is too cold for a heat pump?

There isn’t a hard cut-off for a cold-climate model. It keeps heating well below minus 20, but its capacity shrinks as the temperature falls while the house loses heat faster. The point where those two lines cross is the balance point, and below it the furnace or backup heat fills the gap.

Where that point sits depends on the model, its size and the house. Comparing low-temperature capacity on the spec sheet, not just the nominal size, shows how much of a Markham winter a heat pump can handle alone.

Efficiency numbers on a heat pump quote

SEER2 is the seasonal cooling rating and HSPF2 the seasonal heating rating, and the higher each one is, the less electricity the heat pump draws for the same output. In this climate HSPF2 deserves more weight, because the heat pump spends more hours heating than cooling.

Check that the quote lists matched indoor and outdoor model numbers, since the ratings apply to the pair. Those numbers also let you confirm rebate eligibility.

Ontario heat pump rebates and Markham eligibility

The heat pump rebate open in Ontario now is the Home Renovation Savings Program, run by Save on Energy together with Enbridge Gas. Eligible models can qualify, and what a Markham household receives depends on the home and its current heating fuel. We never quote rebate amounts, because they vary and the program changes.

Older programs such as the Canada Greener Homes Grant are closed, and the Enbridge Home Efficiency Rebate has been replaced. For every heat pump installation in Markham, we confirm the quoted model is on the eligible list and give you the invoice and model details for your application. Save on Energy’s program page (opens in a new tab) has the current terms, and our heat pump rebates guide explains the steps.

Heat pump installation in Markham, from first visit to first heat

Four stages take you from first call to first heat: a home visit with measurements, a written flat-rate quote, the install and commissioning. Each visit gets a two-hour arrival window and a text before the technician pulls up. Heritage homes and multi-head systems take longer, and the quote sets out the timeline.

  • The old AC’s refrigerant recovered to code and the unit removed
  • New outdoor unit levelled on a stand or bracket above the snow
  • Coil, compact air handler or ductless heads installed, with drains routed
  • Copper line set brazed, then nitrogen pressure tested and pulled into a deep vacuum
  • Controls set up, charge verified, and heating and cooling both tested

We handle the permits and inspections the job needs. Before leaving, we show you the thermostat settings and the filter.

Keeping it running: heat pump service and repair

Heat pump service once a year keeps a system that runs in both seasons at its rated efficiency. A visit cleans the outdoor coil and any ductless filters, checks the refrigerant charge and electrical parts, tests the defrost and reversing valve, and makes sure the drains flow.

When a heat pump stops heating, the cause is often a defrost fault, a failed capacitor, a leak or a sticking reversing valve. We find it and price the repair first. Our maintenance plan includes two tune-ups a year with priority booking and covers the furnace too in a dual-fuel home.

What sets the price of a heat pump in Markham?

The price of heat pump installation in Markham depends on the system type and capacity, how many indoor heads you need, any duct or return work, the electrical panel and how easy the outdoor spot is to reach. We quote one flat-rate price after the home visit, and it doesn’t change once work starts.

Factors behind a Markham heat pump quote
FactorWhat it covers
System typeDucted on the furnace, a compact air handler, or ductless heads
CapacityTaken from the heat-loss numbers for your house
Returns and ductsAdded upstairs returns or balancing in older homes
ElectricalA new circuit, and panel capacity where it’s tight
Outdoor locationBrackets, long line sets and placements in heritage districts
FAQ

Heat pump installation questions from Markham homeowners

Our late-1990s AC uses R-22. Is a heat pump the better replacement?

It’s usually worth pricing. R-22 is no longer produced, so a leaking unit is costly to keep going, and a new system is needed either way. A heat pump costs more than an air conditioner but adds heating for much of the year. We price both side by side and tell you which we’d pick for our own home.

Can a heritage home in Unionville get a heat pump?

Yes. Ductless heads usually suit these houses best, since they need no ducts and leave radiators or the existing heating in place. We plan line set routes around plaster walls and tight basements. Because parts of Unionville are heritage districts, check with the city about outdoor equipment visible from the street before we settle the spot.

Where does the outdoor unit go on a Cornell lot?

It depends on the lot. A wall bracket or a narrow side yard can work, as long as the unit gets airflow, service clearance and a raised base above the snow. We also consider neighbours’ windows and any townhome or condo rules before choosing the location, and we route defrost water away from paths.

Will a heat pump work with the original ducts in our Milliken home?

Often, once the return air is sorted out. Many older homes have few upstairs returns, and a heat pump needs steady airflow. We measure static pressure and room airflow, then recommend an added return, balancing or a ductless head for the upper floor if the ducts can’t carry the full load.

Should we replace our furnace at the same time?

Only if it’s due. A sound high-efficiency furnace can stay as the backup in a dual-fuel system. If it’s near 20 years old or needs a major part, replacing it along with the heat pump means one installation and matched equipment. We price both ways so you can compare before deciding.

What does a heat pump do on the coldest Markham nights?

A cold-climate model keeps running, but with less output. In a dual-fuel home, the controls switch to the gas furnace below the balance point, so the house stays warm. In an all-electric design, backup heat strips in the air handler fill the gap. Sizing decides how often either one happens.

Do you service condos and townhomes in Markham Centre?

Yes. Many have a compact furnace, a heat pump air handler or a fan coil in a small closet. We service and replace that equipment and, for condos, confirm the building’s rules on contractors and outdoor units before booking. Ductless heads are an option where the building allows them.

Who installs heat pumps in Unionville or Cornell?

We do, across Markham and in Richmond Hill and North York too. Send the request form or call the number on this page, and we set up a home visit with a two-hour arrival window and a text before the technician arrives. The visit covers heat-loss measurements and the ducts, panel and outdoor spot, then you get a flat-rate quote.

Book a visit

Need heat pump installation in Markham? We’ll call you back to book.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

(647) 496-5598

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

Get an installation quote

Tell us about your home. We’ll call to book a quote visit.

What do you need?
How soon? Optional
Add an email or detailsOptional

Or call (647) 496-5598Used only to book your visit. Privacy