
LG heat pump repair in Toronto covers inverter mini-splits and ducted air handlers, from a unit that won’t heat in a cold snap to one that has dropped off your Wi-Fi. Assurance HVAC Heating & Cooling sends 313A-certified mechanics for the refrigerant work and gives you a flat-rate price first. Planning a swap? See heat pump installation.
Key takeaways
- Inverter mini-splits and LG air handlers repaired across Toronto and the GTA.
- Cold-weather no-heat, Wi-Fi dropouts and weak cooling are common LG problems.
- 313A-certified mechanics, WSIB covered and fully insured.
- Flat-rate price approved before work, with a written workmanship warranty.
- An LG Canada product page ties its extended parts and compressor warranty benefit to registering at Lg.ca.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.
On this page
- Who is LG, and what do we service?
- What an inverter changes when we repair an LG
- LG heat pump repair when the cold snap hits
- LG air handlers in ducted homes
- Wi-Fi control and LG ThinQ problems
- Warm air in summer and water at the indoor unit
- Filter cleaning on LG mini-splits
- LG mini-split error codes: what CH05, CH53 and the others mean
- Registering your LG and what that unlocks
- LG heat pump repair or replacement?
- Booking an LG repair near Toronto, Oakville and Markham
- LG heat pump repair questions
Who is LG, and what do we service?
LG Electronics is part of LG Corporation and is based in Seoul, South Korea. LG Canada lists Mini Splits and Heat Pumps as a category, along with air handlers for ducted homes.
We repair LG equipment as an independent contractor. We tell you what we find on your unit and what it takes to fix, with nothing pitched from the maker.
What an inverter changes when we repair an LG
LG describes its inverter compressor as one that constantly adjusts compressor speed to maintain desired temperature levels. A unit that ramps up and down has more electronics than a fixed-speed one, so power quality and control boards matter.
That makes careful diagnosis important. Replacing a board without testing the sensors, the outdoor fan and the power supply can leave the real fault in place.
LG heat pump repair when the cold snap hits
LG states its inverter heat pumps with LGRED technology maintain efficiency even in extreme temperatures as low as -25 °C, and some Canadian model pages carry titles such as -25 °C Hyper Heating operation and -30 °C Hyper Heating operation.
Those numbers are the maker’s and they differ by model. If your LG is one of these models and blows cool air at -10 °C, that is well inside its stated figure, so we look for icing, a stuck reversing valve, a failed sensor or low charge.
LG air handlers in ducted homes
LG Canada says its air handlers let customers seeking a traditional, ducted solution enjoy inverter technology, with capacities of 18,000 to 48,000 Btu/h, paired with Single, Multi HHV or Multi F Max outdoor units.
For repairs, an air handler adds a blower, a coil and a drain pan to inspect. We also test static pressure in the ducts, since a dirty coil or closed registers can look like a failed heat pump.
Wi-Fi control and LG ThinQ problems
LG says ThinQ lets you access your air conditioner at any time and from anywhere with a Wi-Fi equipped device. When that link breaks, the heat pump itself often still runs fine from its remote or its own controls.
Before booking, check your router, the app login and the unit’s remote. If the unit itself won’t start, it’s a repair call. If only the app is down, our technician can still test the unit’s communication hardware.
Warm air in summer and water at the indoor unit
A mini-split that runs but doesn’t cool is usually dealing with a dirty filter, a dirty coil, a failed fan or a leaking sealed system. Water at the wall points to a blocked drain or a coil that has iced and melted.
Never add refrigerant without finding the leak. Our 313A-certified mechanics isolate it, repair it and recharge to code, then run the system to check temperature drop and pressures.
Filter cleaning on LG mini-splits
LG’s DUALCOOL page mentions convenient cleaning with an EZ sliding filter, and a spec sheet lists a Micro Filter. LG gives no cleaning interval on those pages, so follow your manual.
Turn the unit off, remove the filter as your manual shows, rinse it if the manual says it is washable, dry it fully and refit it. A clogged filter cuts airflow, which can ice the coil and drop heating output. If the filter is clean and the unit still struggles, book a visit.
LG mini-split error codes: what CH05, CH53 and the others mean
These codes are from LG’s Art Cool Premier wall-mounted installation manual (opens in a new tab), which covers the LA090HYV3 to LA240HYV3 LGRED single-zone systems. LG’s Canadian support page says North American indoor units show a fault by blinking two LEDs at the lower right corner, and it writes codes with a CH prefix, so CH05 is code 5.
LG’s manual and that support page describe the blink order differently, so we don’t translate blink counts here; a wired wall controller, if fitted, shows the number directly. The one owner step LG gives is a single power cycle: switch the unit off at the breaker, wait about 5 minutes and switch it back on. If the code comes back, a technician needs to test the part it names.
| Code | What it means | What to do |
|---|---|---|
| 1 | Indoor room temperature sensor error | Book a repair |
| 2 | Indoor inlet pipe sensor error | Book a repair |
| 5 (CH05) | Communication error between the indoor and outdoor units | Breaker off for about 5 minutes, then on once; if it returns, call a technician |
| 6 | Indoor outlet pipe sensor error | Book a repair |
| 10 | Indoor fan motor locked | Book a repair |
| 21 | DC peak (IPM fault): compressor DC voltage was too high | Call a technician |
| 26 | Compressor position error: the compressor is not turning or is locked | Call a technician |
| 32 | Compressor discharge pipe overheating | Call a technician |
| 44 | Outdoor air sensor disconnected or shorted | Book a repair |
| 53 (CH53) | Communication failure from the outdoor unit to the indoor unit | Breaker off for about 5 minutes, then on once; if it returns, call a technician |
| 61 | Outdoor coil temperature too high | Call a technician |
| 67 | Outdoor fan motor locked | Call a technician |
Write down the code or each LED’s blink count, take a photo of the model and serial labels, and note what the unit was doing. Our technicians confirm the code on site and test the sensor, board or motor it points to before ordering parts. LG also notes that a system can show codes beyond this list.
Registering your LG and what that unlocks
A Canadian LG product page says to register your product at Lg.ca to get the extended parts and compressor warranty benefit. So registration is tied to that benefit, which makes it worth confirming before any major repair.
We can’t say whether yours is registered or what it covers, and we don’t handle claims for the maker. Find your confirmation, keep your install paperwork and call LG about coverage before we start if you think a part might be covered.
LG heat pump repair or replacement?
A heat pump lasts about 15 years, so an LG installed recently usually merits repair, while an older one raises the replacement question. This table shows the usual reasoning we use, though the test results on your own unit decide.
| Unit age and fault | Sensible next step |
|---|---|
| Under 8 years, fan, sensor or drain fault | Repair |
| Control board fault, mid-life | Repair if the rest tests well |
| Sealed-system leak or compressor, past 12 years | Compare both options |
| Several faults in one season | Quote a replacement too |
If a swap is on the table, check the heat pump rebates page for current programs. Amounts depend on your home and heating fuel.
Booking an LG repair near Toronto, Oakville and Markham
We repair heat pumps across the GTA, including Toronto, North York, Oakville and Markham, and see the heat pump service in Mississauga for local detail. We’re open 24/7, and for no-heat emergencies technicians go out day or night.
For booked visits you get a two-hour arrival window and a text. You also get a flat-rate price to approve first and a written workmanship warranty on the work. See LG’s air handler page (opens in a new tab) for your model.
Assurance HVAC Heating & Cooling is an independent HVAC contractor, not affiliated with or authorized by LG. Brand names are trademarks of their owners.
LG heat pump repair questions
Do you repair LG mini-splits and LG ducted air handlers?
Yes. We work on LG inverter mini-splits and on air handlers paired with outdoor heat pump units. Diagnosis starts with confirming which layout you have. Ducted systems also need airflow and drain checks, while mini-split faults are usually in the head, sensors, fan or sealed system.
My LG heat pump stopped heating in January. What should I check?
Check the mode and set point, the breaker and the outdoor unit for snow or ice. Clean the filter too. If it still blows cool air, switch it off and call us. LG’s cold-weather figures vary by model, so a technician checks yours against its own specification.
Why won’t my LG connect to the ThinQ app?
Most often it’s the home Wi-Fi, a changed router password or an app login issue. If the heat pump still works from its remote, the unit is fine. If the unit itself has faults, we can test its communication hardware during a repair visit.
Is my LG heat pump still under warranty?
We can’t see that from here. LG Canada says registering at Lg.ca is tied to its extended parts and compressor warranty benefit. Find your registration confirmation and purchase papers, and check with LG before major work if you think a part is covered.
How often should I clean the filter on my LG?
LG’s pages we reviewed don’t give an interval, so follow your manual. A good habit is checking it every month or so in heavy use and washing it when it’s dusty. A clogged filter cuts airflow, heating and cooling output, and can ice the coil.
What does an LG heat pump error code mean?
It points to the part the system flagged. On LG’s Art Cool Premier LGRED wall units, CH05 or code 5 is a communication error between the indoor and outdoor units, and code 1 is the indoor room temperature sensor. Try one power cycle at the breaker, waiting about 5 minutes. If the code returns, book a repair. The table above lists the common codes.
Why is water dripping from my LG indoor unit?
A blocked drain, a very dirty coil or a coil that iced and then thawed are the usual causes. Turn the unit off at the remote so it stops making condensate, protect the floor and book a repair. Running it can soak the wall behind the unit.
How does pricing work for an LG heat pump repair?
After we diagnose the fault, we give you a flat-rate price in writing. You approve it before any work begins, and the repair carries our written workmanship warranty. We don’t publish prices because the part and the labour depend on what we find.
Need LG heat pump repair? We’ll call you back to book.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
