
Heat pump installation in Richmond Hill
(647) 905-9241Open 24/7, day or night
Assurance HVAC Heating & Cooling of Richmond Hill plans heat pump installation in Richmond Hill around a common moment: the original air conditioner in a 1980s to 2000s home finally gives out. From Westbrook and Rouge Woods to Oak Ridges and Jefferson, we compare a cold-climate heat pump with a straight AC swap, size it room by room and give you a flat price before any work. If the old unit might still be saved, start with AC repair in Richmond Hill.
Key takeaways
- Cold-climate ducted and ductless heat pumps for Richmond Hill homes of every age.
- Sized from a room-by-room heat-loss calculation, with ducts, blower and panel checked.
- Installed by 313A-certified mechanics; WSIB covered, fully insured, with a written workmanship warranty.
- A flat-rate price for the whole job, approved before anything starts.
- We check Home Renovation Savings Program eligibility with you before you buy.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling of Richmond Hill service team.
On this page
- Heat pump installation in Richmond Hill when the old AC is due
- Heat pump vs air conditioner: what changes in winter
- Ducted or ductless for a Richmond Hill two-storey?
- Warm upstairs bedrooms in Bayview Hill and Oak Ridges
- Bonus rooms over the garage and finished basements
- Older homes in Mill Pond and Richvale, and houses on baseboards
- Sizing for heat pump installation in Richmond Hill: room by room
- Pairing a heat pump with a 15 to 20 year old furnace
- What to compare on a heat pump quote
- Ontario rebates and the Home Renovation Savings Program
- Where the outdoor unit goes on Richmond Hill lots and townhomes
- Heat pump installation in Richmond Hill, step by step
- Heat pump maintenance and repair in Richmond Hill
- What goes into heat pump installation cost?
- Heat pump installation questions from Richmond Hill homeowners
Heat pump installation in Richmond Hill when the old AC is due
The best time to switch to a heat pump is usually the year your central air conditioner needs replacing. A heat pump takes the same spot outside, connects to the same ducts and cools the same way, but it also heats the house through spring, fall and much of the winter.
Much of Richmond Hill was built from the 1980s through the 2000s, so many original air conditioners are at or past the 15 to 20 year mark, and some still run on R-22, a refrigerant that is no longer produced. When one of those fails, pricing a heat pump beside a new AC often changes the decision.
Heat pump vs air conditioner: what changes in winter
An air-source heat pump is an air conditioner with a reversing valve. In summer it moves heat from inside to outside; in winter the valve flips the flow, and the outdoor coil gathers heat from cold air and sends it indoors. Moving heat takes less energy than making it, so each unit of electricity delivers more than one unit of heat.
What you notice is gentler heat. Air from the registers feels warm rather than hot, and the system runs longer, steadier cycles. In freezing weather the outdoor unit pauses now and then to defrost its coil, which can look like steam rising from the cabinet.
Ducted or ductless for a Richmond Hill two-storey?
Most two-storey homes here suit a ducted heat pump, because they already have a furnace and a full duct system. A ductless mini-split fills specific gaps: a bonus room over the garage, a basement suite, an older house on baseboards, or a bedroom the ducts never served well. Many homes end up using one of each.
| Point of comparison | Ducted heat pump | Ductless mini-split |
|---|---|---|
| Typical home | A two-storey with a furnace, built from the 1980s on | Bonus rooms, basement suites, baseboard or boiler heat |
| Indoor parts | An A-coil on the furnace or a new air handler | One head per room or zone, on the wall or ceiling |
| Upstairs comfort | Depends on duct balance and upstairs returns | The head heats or cools that room directly |
| Install footprint | Uses the old AC’s spot and line route | A small wall opening for each line set |
Warm upstairs bedrooms in Bayview Hill and Oak Ridges
A heat pump won’t fix a hot second floor on its own, because the cause is usually the ducts rather than the equipment. Many Richmond Hill two-storeys were laid out for heating, with too few upstairs returns, so the bedrooms get little cooling airflow. We measure airflow room by room before choosing anything.
The fix might be an added upstairs return, balancing dampers, a variable-speed indoor blower that runs longer at low speed, or a ductless head in the worst bedroom. A variable-speed heat pump also dries the air better than an oversized single-stage AC, which shuts off before it removes the moisture.
Bonus rooms over the garage and finished basements
Rooms over a garage have cold floors in winter, hot ceilings in summer and usually the longest duct run in the house. A single ductless head with its own control is often the most direct fix, leaving the main system to look after the rest of the house.
Finished basements in Westbrook, Rouge Woods, Doncrest and Devonsleigh raise a different question when they become a suite. A ductless mini-split gives that space its own heat, cooling and thermostat, with the outdoor unit set beside the main condenser or on a wall bracket.
Older homes in Mill Pond and Richvale, and houses on baseboards
Older Richmond Hill houses, such as those near the Mill Pond core or the remaining post-war homes in Richvale and North Richvale, may have ductwork never laid out for central air, or none at all where heat comes from baseboards. Ductless heads can carry most of the heating and all of the cooling without opening walls for new ducts.
Some custom homes in Richvale and Bayview Hill heat a basement or garage with a boiler and in-floor loops; a ductless head adds cooling there and leaves the radiant floor alone. Our HVAC contractor in Richmond Hill page covers those boiler systems.
Sizing for heat pump installation in Richmond Hill: room by room
Every system we quote is sized from a room-by-room heat-loss calculation rather than the tonnage on the old AC. A house that has gained new windows, attic insulation or a finished basement since it was built loses heat differently, and a heat pump has to be sized for the heating season, not only for July.
The same numbers decide how air is split between floors and whether any duct runs need resizing. In a dual-fuel Richmond Hill home they also show the outdoor temperature at which the heat pump should hand over to the furnace.
Pairing a heat pump with a 15 to 20 year old furnace
A hybrid heat pump system keeps your gas furnace for the coldest days while the heat pump covers cooling and most of the heating. Because the heat pump uses the furnace’s blower and cabinet, the furnace’s condition matters: a sound one can stay, and one close to 20 years is often better replaced at the same time.
Doing both together means one project and matched controls. If the furnace is healthy, a furnace repair visit or a tune-up may be all it needs for now.
Will the electrical panel take it?
A heat pump needs a dedicated circuit, and an all-electric design with backup heat strips needs more again. Some Richmond Hill panels have room and some don’t, so we check at the home visit and tell you before quoting.
What to compare on a heat pump quote
Compare Richmond Hill quotes on the same terms: the model numbers, the heating capacity at low outdoor temperatures, the HSPF2 and SEER2 ratings, and exactly what is included. A cheaper quote that leaves out the line set, drain, controls or permit isn’t really cheaper.
- Outdoor and indoor model numbers, so you can check them against the rebate list
- Heating capacity at cold temperatures, not just the nominal size
- Line set, stand or bracket, condensate drain and electrical work
- Thermostat or dual-fuel controls, permits and removal of the old AC
Our quotes put all of it in writing, with one flat-rate price.
Ontario rebates and the Home Renovation Savings Program
The one heat pump rebate open right now is the Home Renovation Savings Program, delivered jointly by Save on Energy and Enbridge Gas. Eligible models qualify, and the amount a Richmond Hill household can receive varies with the house and the fuel it currently heats with, which is why we don’t print figures.
Other programs you may read about, including the Canada Greener Homes Grant and the Oil to Heat Pump Affordability program, have closed. Every heat pump installation in Richmond Hill we quote uses a model checked against the eligible list, and we supply the invoice and specifications for your application. The program page (opens in a new tab) has the current rules, and our rebates page explains the steps.
Where the outdoor unit goes on Richmond Hill lots and townhomes
The outdoor unit needs free airflow, a raised base above the snow line, room for service and a path for defrost water that won’t freeze on a walkway. On most detached lots, heat pump installation in Richmond Hill puts it in the old AC’s place, lifted on a stand, and the old route through the wall can often be used again.
Townhomes and condos along Yonge Street and near Langstaff are tighter. There we look at side and rear clearances, wall brackets and any condo corporation rules before quoting, and a compact air handler or ductless system often suits the mechanical space best.
Heat pump installation in Richmond Hill, step by step
Each job follows the same four stages: a home visit, a written quote, the installation and commissioning. We confirm a two-hour arrival window for each visit and text you when the technician is on the way, and the quote states how long the install will take.
- Home visit: heat-loss measurements, plus a look at the ducts, blower, panel and outdoor spot.
- Quote: one flat-rate price with ducted, ductless or hybrid options side by side, and a rebate eligibility check.
- Install: old AC refrigerant recovered, outdoor unit set, coil or heads fitted, line set brazed, pressure tested and evacuated.
- Commissioning: charge set to the manufacturer’s figures, defrost and changeover controls tested, and both modes run.
We handle the permits and inspections the job needs, then walk you through the thermostat before leaving.
Heat pump maintenance and repair in Richmond Hill
A heat pump does two jobs, so it runs far more hours each year than an air conditioner, and yearly heat pump maintenance protects both its efficiency and its lifespan of about 15 years. A spring or fall visit cleans the coils, checks the charge, tests defrost and the reversing valve, and clears the drains.
When something goes wrong, the usual culprits are a failed capacitor or contactor, an outdoor fan motor, a defrost control that lets ice pile up, a refrigerant leak, or a clogged drain on a ductless head. We find the fault and give you a flat price to approve first. Our maintenance plan covers two tune-ups a year with priority booking.
What goes into heat pump installation cost?
Heat pump installation cost comes down to the system type and size, the number of indoor heads, the condition of the ducts and furnace, and any electrical work. Once we’ve seen the house, you get one flat-rate price, and it holds once the job starts.
| Factor | What it involves |
|---|---|
| System type | A ducted swap, a multi-head ductless system or a mix of both |
| Capacity | Set by the heat-loss numbers, not the old AC’s size |
| Furnace condition | A sound furnace stays; an old one may be replaced at the same time |
| Ducts | Added upstairs returns or balancing dampers in two-storey homes |
| Electrical | A dedicated circuit, and more panel capacity if it’s tight |
Rebates, where a home qualifies, are claimed by the homeowner after the install and sit outside our price.
Heat pump installation questions from Richmond Hill homeowners
Our AC is 18 years old. Should we replace it with a heat pump?
Often, yes. At that age an air conditioner is past the usual 12 to 15 years, and a heat pump adds heating for much of the year for the cost difference over a straight AC swap. We price both, along with the furnace if it’s the same age, and tell you which we’d choose for our own home.
Will a heat pump keep up in an Oak Ridges winter?
A cold-climate model keeps heating into the minus 20s, though with less output as it gets colder. In a dual-fuel setup the gas furnace covers the deepest cold, so the heat pump handles most of the season and the furnace the rest. The heat-loss calculation decides where that split falls for your house.
Can a heat pump fix our hot upstairs?
Sometimes, but rarely by itself. Upstairs heat is mostly an airflow problem. A variable-speed heat pump helps by running longer at low speed, and a ductless head in the worst room solves it directly, but an added upstairs return or balanced ducts are often part of the fix. We measure before recommending anything.
Is a heat pump worth it in a house with electric baseboards?
Usually, yes. Baseboards turn each unit of electricity into one unit of heat, while a heat pump moves several units of heat for each one it uses in mild weather and still beats baseboards in the cold. Ductless heads in the main rooms carry most of the load, with the baseboards kept as backup.
Do we need a new furnace to add a heat pump?
Not if the furnace is sound. The heat pump’s coil sits on the furnace and shares its blower, so we check the blower’s airflow and the furnace’s age. A furnace near 20 years is usually worth replacing at the same time, since one project with matched controls costs less than two separate jobs.
How much does a heat pump cost to install in Richmond Hill?
It depends on the system type and size, how many ductless heads you need, the state of the ducts and furnace, and any electrical work, so we don’t quote from a phone call. After a home visit and heat-loss calculation you get one flat-rate price for the whole job, approved before work starts.
Do you install heat pumps in townhomes near Langstaff and Yonge Street?
Yes. Townhomes need careful outdoor unit placement and sometimes a compact air handler or ductless system that fits a small mechanical room. Where there’s a condo corporation, we go over its rules with you before quoting. Beyond Richmond Hill, we also work in Markham, Vaughan and North York.
How do I book heat pump installation in Richmond Hill?
Send the request form or call the number on this page. We call back to book a home visit in a two-hour arrival window and text when the technician is on the way. The visit covers the heat-loss measurements, the ducts and panel, and a written flat-rate quote with rebate eligibility checked.
Need heat pump installation in Richmond Hill? We’ll call you back to book.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
