
A good HVAC maintenance checklist splits the year into two kinds of jobs: the simple ones you can do yourself, and the ones that belong to a technician. Filters, vents and alarms are yours. Burners, refrigerant and electrical parts are not. This guide walks through the seasons in order, with a checklist for each, and shows how a furnace maintenance visit fits in.
Key takeaways
- Homeowner jobs are filters, registers, clear outdoor equipment and vents, and testing alarms.
- A technician handles gas, refrigerant, electrical parts and anything inside the equipment.
- The furnace gets its tune-up in fall and the air conditioner gets its tune-up in spring.
- A water heater, heat pump or boiler can be added to the same seasonal schedule.
- Ontario does not require yearly furnace maintenance, but many warranties ask for proof of it.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.
On this page
- Why an HVAC maintenance checklist helps
- HVAC maintenance checklist at a glance
- Fall HVAC maintenance checklist
- What the fall furnace tune-up covers
- Winter checks that keep the heat on
- Spring HVAC maintenance checklist
- What the spring AC tune-up covers
- Summer checks between visits
- Heat pumps, boilers and water heaters
- What is not a homeowner job
- Maintenance plan, one-time tune-ups and warranty paperwork
- Gas and carbon monoxide safety
- HVAC maintenance checklist: common questions
Why an HVAC maintenance checklist helps
An HVAC maintenance checklist turns upkeep into a routine, so small problems get caught before they turn into a breakdown on the coldest or hottest day. Most failures build slowly: a clogged filter, a coated sensor, a drain that is slowly plugging up. A seasonal list means each system gets attention at the right time.
It also keeps the right person on each job. You do the simple, safe tasks, and a technician does the rest.
HVAC maintenance checklist at a glance
The year runs on two main visits and a handful of homeowner jobs in between. A fall visit prepares the furnace for the heating season, and a spring visit prepares the air conditioner for summer. The table shows who does what, season by season.
| Season | You can do | A technician does |
|---|---|---|
| Fall | Replace the filter, open registers, test CO alarms, clear the vent pipes | Furnace tune-up, with a safety and combustion check |
| Winter | Check the filter monthly, brush snow off vents and outdoor units | Repairs if the furnace short cycles, makes noise or loses heat |
| Spring | Replace the filter, check the condensate drain for water, clear leaves from the outdoor unit | AC tune-up, before the first hot weekend |
| Summer | Check the filter, keep the outdoor unit clear, watch for water or ice | Repairs if cooling weakens or the unit stops |
Fall HVAC maintenance checklist
Fall is the time to get the heating system ready before the first cold snap. Start with the jobs you can do yourself, then book the furnace tune-up while technicians have room in the schedule. Do these in September or October, so anything you find can still be fixed before it is cold.
- Replace the furnace filter with the size printed on the frame.
- Open every register, and move furniture and rugs off supply registers and return grilles.
- Test your carbon monoxide and smoke alarms, and replace any that are past their date.
- Look at the outdoor intake and exhaust pipes, and clear leaves and debris by hand.
- If you have a whole-home humidifier, ask for its pad to be changed at the fall tune-up.
- Set the thermostat to Heat, check the batteries and run the furnace briefly.
If the furnace will not start during that first run, our furnace not turning on guide covers the checks.
What the fall furnace tune-up covers
The fall visit is the technician’s part of the checklist. A TSSA-certified gas technician cleans and tests the parts that wear, measures how the furnace is burning and heating, and checks the safety controls and venting. You get a written report afterwards, and any repair comes with a flat-rate price you approve first.
- Burners, flame sensor and ignitor
- Heat exchanger, inspected for cracks
- Limit switches and other safety controls
- Venting, condensate drain and filter
- Blower motor and electrical connections
- Carbon monoxide test at the furnace
Winter checks that keep the heat on
Winter upkeep is light but it matters, because the furnace works hardest now. Check the filter every month and change it when it looks grey, clear snow and ice from the outdoor vent pipes after storms, and listen for new noises. Catching a change early is easier than repairing a lockout at night.
- Check the filter monthly, and replace it when light barely shows through.
- Brush snow, ice and frost off the plastic vent pipes by hand after storms.
- Keep registers and returns clear, and keep stored items away from the furnace.
- Note any new smell, noise or short cycling, and call before it fails.
A furnace that fails anyway is a no-heat emergency. Our no heat in the house guide covers the order to work through.
Spring HVAC maintenance checklist
Spring is the time to wake the air conditioner up before the first heat wave. Clean up around the outdoor unit, check the filter and the drain, then book the AC tune-up while the schedule is still open. Aim for April or May, so a fault found now is fixed well before it is hot.
- Clear leaves, sticks and cottonwood from around and on top of the outdoor unit, leaving about 60 cm of space.
- Brush leaves and cottonwood off the outdoor unit by hand or with a soft brush, and never use a pressure washer or chemicals.
- Replace the furnace filter, since the same blower runs the air conditioner.
- Look at the condensate pan and drain for water or a visible clog.
- If you have a whole-home humidifier, set its humidistat to Off or its lowest setting.
- Set the thermostat to Cool and run the system briefly to confirm it responds.
What the spring AC tune-up covers
The spring visit is the technician’s part of the cooling checklist. A 313A-certified technician cleans the outdoor coil, inspects the indoor coil, tests the electrical parts and checks refrigerant pressures without topping up blindly, since low pressure usually means a leak that needs finding first. They clear the drain and confirm the system cools as it should.
- Outdoor coil cleaned, indoor coil inspected
- Capacitor, contactor and fan motor tested
- Refrigerant pressures checked, with any leak found before adding refrigerant
- Condensate drain cleared and flushed
- Temperature drop across the coil measured
- Thermostat and settings checked
If the air conditioner already has a problem, our AC repair page covers the common faults.
Summer checks between visits
Summer needs only light attention if the spring work was done. Keep the outdoor unit clear of weeds, grass clippings and fences closing in, check the filter monthly, and watch for water around the furnace or ice on the lines. Weak cooling or ice are signs to call rather than keep running the unit.
Heat pumps, boilers and water heaters
Not every home has only a furnace and an air conditioner, and the checklist adapts to what you have. A heat pump runs in both seasons, so it gets seasonal checks. A boiler gets a yearly service before the heating season, and a water heater can be added to the same schedule, with descaling for a tankless unit.
- Boiler: read the pressure gauge now and then, and call if it is in the red or the relief valve drips.
- Tank water heater: leave the relief valve alone unless the manual tells you to test it, and look for leaks at the base.
- Heat pump: keep the outdoor unit clear of snow, ice and leaves by hand.
- Tankless water heater: ask a technician about descaling, especially in hard water.
What is not a homeowner job
Some jobs look simple on video but are not safe for a homeowner. Anything involving gas, refrigerant, wiring or the inside of the equipment belongs to a licensed technician. If a job is not on the homeowner lists above, leave it for the visit.
- Opening the furnace, burner compartments or electrical boxes
- Adjusting a gas valve, or resetting safety switches and limits
- Adding or topping up refrigerant
- Pressure washing or using chemicals on coils
- Removing a water heater’s anode rod, or capping or plugging a relief valve
Maintenance plan, one-time tune-ups and warranty paperwork
You do not need a plan to book a tune-up, because a one-time furnace or AC visit follows the same checklist. Our maintenance plan schedules the fall furnace visit and the spring AC visit for you, with a reminder before each, priority booking when it is busy and member pricing on repairs.
Ontario does not require yearly furnace maintenance by law, but many manufacturer warranties ask for proof of regular maintenance, so check your warranty papers and keep each written report.
Gas and carbon monoxide safety
A seasonal checklist also keeps your alarms honest. Ontario requires carbon monoxide alarms in homes with a fuel-burning appliance, a fireplace or an attached garage, next to every sleeping area and, since January 1, 2026, on every storey, and the province’s carbon monoxide safety page (opens in a new tab) explains where they go. Test them as the maker advises, and replace them by the date printed on the alarm.
- CO alarm sounding: get everyone, pets included, outside and call 911.
- Gas smell: leave the house without touching switches or phones, then call Enbridge Gas at 1-866-763-5427 from outside.
Our carbon monoxide alarm going off guide covers what to do in full. For a furnace fault, see our furnace repair page.
HVAC maintenance checklist: common questions
What should be on an HVAC maintenance checklist?
Homeowner jobs such as replacing filters, keeping registers and outdoor equipment clear, and testing alarms, plus two technician visits: a fall furnace tune-up and a spring AC tune-up. Boilers, heat pumps and water heaters add their own seasonal checks, so the list is built around the equipment in your home.
How often should HVAC maintenance be done?
Once a year for each major system is the usual schedule: the furnace in fall before the heating season and the air conditioner in spring before the first heat wave. Filters need checking monthly, and alarms need testing as the maker advises.
Can I do HVAC maintenance myself?
Some of it. You can replace filters, open registers, clear snow and leaves from outdoor equipment by hand, check a condensate drain for water and test alarms. Gas, refrigerant, electrical work and anything inside the equipment belong to a licensed technician.
What is the best time of year for a furnace tune-up?
Early fall, in September or October, before the first cold snap. That leaves time to fix anything the tune-up finds, and technicians have more room in their schedules than they will in the first cold week. The air conditioner is best done in spring.
Is yearly furnace maintenance required in Ontario?
Ontario does not require it by law. Many manufacturer warranties do ask for proof of regular maintenance, though, so check your warranty papers. A yearly tune-up also catches worn parts and safety problems early, and it gives you a written record of the work.
Does a maintenance plan include the water heater?
It can. We set the plan up around the equipment in your home, so a water heater, heat pump or boiler can be included, with descaling for a tankless unit. Tell us what you have when you ask for a quote, and we build the plan around it.
How long does a tune-up take?
A furnace tune-up usually takes about one to two hours, and an air conditioner tune-up about an hour. A system with a problem, or a home with several systems, can take longer. You get a two-hour arrival window and a text when the technician is on the way.
Who does HVAC maintenance in the GTA?
Our TSSA-certified gas technicians and 313A-certified AC mechanics service systems across Toronto, North York, Richmond Hill, Vaughan, Markham, Mississauga and Oakville. You approve a flat-rate price before any repair, and every repair carries our written workmanship warranty. We are open 24/7 for emergencies.
Due for a tune-up? We’ll call you back to book.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
