
How long do water heaters last? A tank typically lasts 8 to 12 years, and a tankless unit about 20, but water quality, maintenance and installation can move those numbers either way. This guide explains what wears a heater out, the signs one is near the end, and how to decide between a repair from water heater repair and a replacement.
Key takeaways
- A tank water heater typically lasts 8 to 12 years. A tankless unit lasts about 20.
- Hard water, sediment and a worn anode rod shorten a tank’s life the most.
- Rust-coloured water, leaks at the body, rumbling and short supply point to the end.
- A leak from the tank body means replacement. A failed part on a newer tank can be repaired.
- We give a flat-rate price for repair and replacement so you can compare.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.
On this page
- How long do water heaters last, tank and tankless?
- How long do water heaters last? What wears out a tank
- The anode rod: the part that buys a tank time
- Water quality and sediment
- Signs a water heater is near the end
- How to find out how old your water heater is
- How long do water heaters last before repair stops paying?
- How to make a water heater last longer
- Gas smell and carbon monoxide safety on an old heater
- Choosing a replacement when the time comes
- How long do water heaters last: common questions
How long do water heaters last, tank and tankless?
A tank water heater typically lasts 8 to 12 years, and a tankless water heater about 20 years with regular care. These are general industry figures, not promises. A tank in soft water that’s well looked after can outlast them, and one in hard water that’s never been flushed can fall short.
| Type | Typical lifespan | Main things that shorten it |
|---|---|---|
| Tank, gas or electric | 8 to 12 years | Sediment, a worn anode rod, hard water |
| Power vent or direct vent tank | 8 to 12 years | The same, plus venting and fan wear |
| Tankless, gas or electric | About 20 years | Scale in the heat exchanger, skipped descaling |
How long do water heaters last? What wears out a tank
A tank fails because the steel inside rusts through. Hot water is hard on steel, so a glass lining and an anode rod protect it. Once the lining cracks or the rod is used up, the steel corrodes, and eventually water seeps out of the body, which can’t be repaired.
Sediment speeds this up. Minerals settle at the bottom, make the burner or element work harder and create hot spots that stress the lining. Hard water is common in the GTA, so this matters here.
The anode rod: the part that buys a tank time
The anode rod is a metal rod, usually magnesium or aluminum, that corrodes in place of the tank. It’s sacrificial, so it wears away over the years, and once it’s gone the tank steel starts to rust. A technician can check its condition and replace it before the tank pays the price.
Never remove an anode rod yourself. It’s tightly threaded, may be seized and needs the right tools. A rod change is one of the least costly ways to add years to a tank that’s otherwise sound.
Water quality and sediment
Hard water leaves scale. In a tank, it settles as sediment and in a tankless unit it builds up inside the heat exchanger. Both cut efficiency and shorten life, and both are manageable with routine care.
A yearly flush slows sediment in a tank, and our how to flush a water heater guide shows how. For tankless units, descaling does the same job, as our tankless descaling guide explains.
Signs a water heater is near the end
Most tanks give warning before they fail. No single sign means a tank is finished, but several together, especially past 10 years, usually mean it’s time to plan a replacement before the water ends up on the floor.
- Water around the base of the tank, or rust streaks on the tank body
- Rust-coloured or metallic-tasting hot water
- Rumbling, popping or banging as the tank heats
- Hot water that runs out faster than it used to
- Repeated repairs in a short stretch
- A tank over 10 to 12 years old
How to find out how old your water heater is
The rating label on the side of the tank carries a serial number, and on most makers that number encodes the month and year of manufacture. The code differs between makers, so the maker’s website or a technician can decode it. A tank can also have a date from the original install.
If the label is missing or unreadable, a technician can usually judge age from the model and the condition of the tank. Our rent or buy guide helps if the tank isn’t yours.
How long do water heaters last before repair stops paying?
A repair makes sense when the tank body is sound and the failed part is small. Replacement makes more sense when the tank is old, leaking from the body or throwing up several faults at once. The table gives a general guide.
| Situation | Usually better to |
|---|---|
| Under 8 years old, failed element, thermostat or thermocouple | Repair |
| Under 8 years old, sediment noise or a smelly tank | Flush, check the anode rod or repair |
| 8 to 12 years old, one repair needed | Repair, and plan ahead |
| Over 10 to 12 years old, several repairs | Replace |
| Leaking from the tank body at any age | Replace |
| Rusty hot water with a tired, old tank | Replace |
How to make a water heater last longer
A little routine care adds years to a tank, and most of it costs very little in money or time. The list below shows what helps and what is best left to a technician, so you can start with the easy wins.
- Flush a tank about once a year, with the gas set to off or the power off, after it cools, with a hose to a floor drain, and stop if the drain valve is brittle or won’t close.
- Have a technician check the anode rod and replace it before it’s used up.
- Have a tankless unit descaled on the schedule the maker gives, often yearly in hard water.
- Keep the area around the tank clear and watch for drips or rust.
- Leave the temperature at the usual setting. Water heaters are commonly set around 49°C at the tap.
Gas smell and carbon monoxide safety on an old heater
An older gas water heater can develop venting and burner problems, so safety matters more as it ages. Old gas units can leak, so if you smell gas, get everyone out, use no switches or indoor phone, and call Enbridge Gas at 1-866-763-5427.
- A carbon monoxide alarm sounding near an older heater means leaving with the pets right away and calling 911.
- Soot, scorching or a yellow flame mean switching the tank off and calling.
- A gas heater counts as a fuel-burning appliance, so your Ontario home needs working CO alarms next to each sleeping area and on every storey, as do homes with a fireplace or an attached garage.
See Ontario’s carbon monoxide safety (opens in a new tab) page for guidance on alarms.
Choosing a replacement when the time comes
A replacement is a chance to rethink the type and size. Our tank vs tankless water heater guide compares the two, and our water heater installation page explains how a new unit is sized, vented and installed.
Replacement is quoted flat-rate, you approve it before work begins, and the installation is backed by our written workmanship warranty. Our maintenance plan comes with two seasonal tune-ups.
How long do water heaters last: common questions
How long do water heaters last on average?
A tank water heater typically lasts 8 to 12 years, and a tankless unit about 20. Water hardness, sediment, the anode rod and maintenance all move the figure, so treat it as a guide. A tank past 10 years old is worth watching closely and planning to replace.
How do I know when my water heater needs replacing?
Look for water around the tank, rust-coloured hot water, rumbling noises, short hot water supply and repeated repairs, especially past 10 years. A leak from the tank body means replacement. A technician can confirm and give you a flat-rate price for repair and replacement.
Can I make my water heater last longer?
Yes. Flush a tank about once a year with the gas or power off, after it cools and with a hose to a floor drain, have a technician check the anode rod, have a tankless unit descaled on schedule and keep an eye out for drips and rust. Routine care can’t promise a number of years, but it helps a tank reach the upper end of its range.
Does hard water shorten a water heater’s life?
It can. Hard water leaves scale, which settles as sediment in a tank and builds up inside a tankless unit’s heat exchanger. Both reduce efficiency and strain the heater. Hard water is common in the GTA, so regular flushing or descaling is worth the effort.
How can I tell how old my water heater is?
Check the rating label on the side of the tank. The serial number usually encodes the month and year of manufacture, though the code differs between makers. The maker’s website or a technician can decode it. A tank with a missing label can often be aged by its model and condition.
Is it worth repairing a 10-year-old water heater?
Sometimes. If the tank body is sound and one part has failed, a repair can be good value. If the tank is leaking, rusty or has needed several repairs, replacement usually makes more sense. We give a flat-rate price for both so you can compare.
Do tankless water heaters really last 20 years?
About 20 years is a common figure with regular descaling and care, and it’s longer than a tank. Hard water, skipped maintenance and heavy use can shorten it. Parts such as fans and sensors may need replacing along the way. It’s a general guide, not a promise.
Who can replace a water heater in the GTA?
Our TSSA-certified gas technicians replace and service tank and tankless water heaters across Toronto, Oakville, Mississauga, Vaughan, Markham, Richmond Hill and North York. We work on every major brand and are open 24/7. You get a flat-rate price for the replacement and for any repair, to approve before work begins.
Planning a replacement? We’ll call you back to book a quote visit.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
