---
title: "Water heater leaking: what to do first | Assurance HVAC"
description: "Water heater leaking? Shut off the cold water valve and the gas or power first, then learn where the leak comes from and when the tank needs replacing."
canonical: https://assuranceheatingandcoolinghvac.com/guides/water-heater-leaking/
last_updated: 2026-11-05
---

Homeowner guides

# Water heater leaking: what to do first

[(647) 692-0819](tel:+16476920819) Open 24/7, day or night

A water heater leaking onto the basement floor is stressful, but the first three steps are simple and quick, and they limit the damage while you wait. This guide covers what to shut off, how to tell where the water is coming from, which leaks can be fixed, and when to book [water heater repair](https://assuranceheatingandcoolinghvac.com/services/water-heater-repair-toronto/) or a replacement.

[Call (647) 692-0819](tel:+16476920819) Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

## Key takeaways

- Close the cold water valve on top of the tank, shut off the gas or power, then call.
- Leaks at fittings or valves can often be repaired. A leak from the tank body means replacement.
- Never plug, cap or tie off the relief valve or its discharge pipe.
- Never remove an anode rod, and don’t tighten fittings yourself, especially on a hot tank.
- We’re open 24/7, and you approve a flat-rate price before any work starts.

Last updated November 5, 2026. Written and reviewed by the Assurance HVAC Heating & Cooling service team.

Need a technician?

Flat-rate price before any work starts.
[(647) 692-0819](tel:+16476920819) Request a technician online

**On this page**

- Water heater leaking: the first three steps
- Where a water heater leaking comes from
- Water heater leaking from the bottom
- Leaks at the top, the fittings and the pipes
- A relief valve dripping or running
- Drain valve leaks and sediment
- Condensation or a real leak?
- Gas, electrical and scald safety around a leaking tank
- What not to do when a tank is leaking
- What a technician does for a water heater leaking
- If the tank is a rental
- Water heater leaking: common questions

## Water heater leaking: the first three steps

When a tank is leaking, stopping the water supply matters most. Close the cold water valve on top of the tank, turn the gas control to off or switch off the breaker, and call a technician. Those three steps stop the tank refilling and stop it heating an empty or damaged tank.

- Close the cold water valve on the pipe at the top of the tank, a round handle closes clockwise, and a lever closes when it sits across the pipe.
- Gas tank: turn the gas control dial to Off. Electric tank: switch off its breaker at the panel.
- Move belongings away from the water and use towels or a bucket to catch drips.
- If water is spreading near electrical outlets or the panel, stay clear and call for help.

Leave the electrical panel and the tank’s access covers closed. Hot water from a leak can scald, so keep children and pets away.

## Where a water heater leaking comes from

Where the water appears tells you a great deal, so take a moment to look before you wipe it up. Dry the tank and the pipes with a towel, then watch for the first drop. Note whether it’s at the top, the side or the bottom, and whether it’s clean, rusty or warm.

Where the water appears, the likely cause and what happens next
Where you see water | Likely cause | What it usually means |
Top, at the pipe connections | Loose or corroded inlet or outlet fitting | Often repairable |
Side or near the upper tank, from a pipe | Relief valve or its discharge pipe | Call; never plug it |
Low on the tank, at a small valve | Drain valve seal | Usually repairable |
Bottom, from under the tank | Tank body corroded through | Replacement |
Around the electric element covers | Element gasket or loose element | Technician |
Beads on cold pipes or the tank | Condensation, not a leak | Dry it and watch |

## Water heater leaking from the bottom

A water heater leaking from the bottom is the worst case, because it usually means the tank has failed. Inside every tank, the steel slowly corrodes, and once it corrodes through, water seeps out from the base. A tank that has leaked through its body can’t be patched or repaired.

Before you decide, check that the water isn’t coming from the drain valve, the fittings or a nearby pipe running down the tank. If it truly comes from the body, plan for replacement. Our [water heater installation](https://assuranceheatingandcoolinghvac.com/services/water-heater-installation-toronto/) page explains how a new tank is sized and installed.

## Leaks at the top, the fittings and the pipes

Leaks at the top usually come from the connections where the cold supply and hot outlet pipes meet the tank. Fittings loosen with years of heating and cooling, and mineral scale and corrosion can wear through them. The tank itself may be perfectly sound.

These leaks are often repairable, but they need proper tools and the right parts. Don’t keep tightening fittings on a hot tank, which can strip threads or make the leak worse. Let a technician replace the connection or the dielectric fitting.

## A relief valve dripping or running

Every tank has a temperature and pressure relief valve, a safety device that opens when pressure or temperature climbs too high, with a pipe leading down toward the floor. A little water from the discharge pipe can mean the valve is doing its job, or that it has worn out and no longer seats.

Never plug, cap or tie off the valve or its pipe, and don’t touch it beyond what the manual asks you to do. A valve that keeps dripping, or runs steadily, is a reason to call. In many homes, a closed plumbing system with no expansion tank raises pressure each time the tank heats, and a technician can check for that.

## Drain valve leaks and sediment

The drain valve sits low on the tank, and a slow drip there is common on older tanks. Sediment can stop the valve closing fully, and old plastic valves turn brittle and crack. A drip is often a repair rather than a replacement.

Don’t crank on a drain valve that drips or won’t close. If it’s brittle, leave it. Our [flushing guide](https://assuranceheatingandcoolinghvac.com/guides/how-to-flush-a-water-heater/) explains why a valve that won’t close is a stopping point, and a technician can replace it with a better one.

## Condensation or a real leak?

Not every wet spot is a leak. On a cold day, a gas tank that is firing can drip condensation from the flue or burner area, and cold supply pipes sweat in humid weather. These drops are usually small, clear and come and go.

A real leak keeps coming, gets worse, leaves rust streaks or stains, or makes a puddle that returns after you dry it. If you’re not sure, dry everything, put a dry paper towel under the tank and check again after a while. If it’s wet again, treat it as a leak.

## Gas, electrical and scald safety around a leaking tank

Water and gas or power don’t mix, so shutting off the energy source is part of every leak response. A gas smell means leaving immediately and avoiding switches and indoor phones, then calling Enbridge Gas at 1-866-763-5427 once outside.

- Carbon monoxide alarm sounding near the tank: take everyone out, pets as well, and phone 911.
- Ontario requires carbon monoxide alarms next to sleeping areas and on every storey of homes with a fuel-burning appliance, a fireplace or an attached garage, so keep yours working.
- Never step in standing water near a panel, outlets or an electric tank.
- A leaking tank can spill water much hotter than the setting commonly used at the tap, around 49°C, so keep children and pets back.

More on alarms and safe operation is on Ontario’s [carbon monoxide safety](https://www.ontario.ca/page/carbon-monoxide-safety) page.

## What not to do when a tank is leaking

The urge to fix a leak yourself is strong, but a few common attempts do real harm. The tank holds dozens of litres of hot water under pressure, with a gas burner or electric elements attached, so the steps you take should be limited to shutting things off.

- Don’t plug, cap or tie off the relief valve or its discharge pipe.
- Don’t remove an anode rod or open the tank.
- Don’t tighten fittings or the drain valve yourself; leave that to a technician.
- Don’t keep the tank heating after the water supply is shut off.
- Don’t use sealant or epoxy on the tank body.

## What a technician does for a water heater leaking

A TSSA-certified gas technician finds the true source first, by drying the tank and checking each fitting, valve and connection. If the leak is repairable, the technician quotes the fix. If the tank body has failed, you get a flat-rate replacement quote to compare.

Repairs carry our written workmanship warranty. For nearby help, see our [water heater repair in Mississauga](https://assuranceheatingandcoolinghvac.com/service-area/mississauga/water-heater-repair/) page, and we serve the other six areas too.

## If the tank is a rental

Many homes rent their water heater. If yours is rented, shut off the water and the gas or power as above, then read your own rental agreement to see who to call for a leak. Our [rent or buy guide](https://assuranceheatingandcoolinghvac.com/guides/rent-or-buy-a-water-heater/) explains what to check in an agreement before changing anything.

Find these guides useful? Add Assurance HVAC Heating & Cooling as a preferred source, and Google shows our articles more often in your Top Stories when you search.
[Add as a preferred sourceon Google](https://www.google.com/preferences/source?q=assuranceheatingandcoolinghvac.com)

FAQ

## Water heater leaking: common questions

**Why is my water heater leaking from the bottom?**

Most often the tank itself has corroded through and can’t be repaired. Before you assume that, check that the water isn’t coming from the drain valve, a fitting or a pipe that runs down the tank. If it truly seeps from the base, close the cold water valve, shut off the energy and plan for replacement.

**Can I keep using a leaking water heater?**

It’s best not to. A leak gets worse, can cause costly water damage and, with gas or electricity involved, creates real hazards. Close the cold water valve on top, turn the gas control to off or switch off the breaker, and call. Use another hot water source until it’s repaired.

**Where is the cold water valve on a water heater?**

It’s on the cold supply pipe entering the top of the tank, usually a lever or round handle. A round handle closes clockwise; a lever closes when it sits across the pipe. If it’s stiff or won’t close, don’t force it. Find your home’s main water shutoff instead, and call for help.

**Is a dripping relief valve dangerous?**

A relief valve drips for a reason, either because pressure or temperature rose or because the valve has worn out. Never plug or cap it, and touch it only as far as the manual asks. If it keeps dripping or runs steadily, switch off the heater if you safely can and call a technician.

**Can a leaking water heater tank be repaired?**

Leaks at fittings, valves and gaskets are often repairable. A leak from the tank body is not, because the steel has corroded through and any patch would fail. A technician finds the source and tells you which kind you have before you approve any work.

**Is water pooling around my water heater always a leak?**

No. Condensation on cold pipes or a firing gas tank can leave small clear drops, especially in humid weather. A real leak returns after drying, grows or leaves rust. Dry the area, check again after a while and call if it comes back.

**Does a leaking water heater need to be replaced?**

Only when the tank body is leaking, or when an older tank has several problems at once. A leak at a fitting or valve on a newer tank is usually worth fixing. Our technicians give you a flat-rate price for the repair and for replacement so you can compare.

**Who can fix a water heater leaking in the GTA?**

Technicians from Assurance HVAC Heating & Cooling repair and replace tank and tankless water heaters in Mississauga, Oakville, Vaughan, Markham, Richmond Hill, North York and Toronto. They are TSSA-certified, they work on all major brands, and phones are answered 24/7. A flat-rate price is yours to approve before anyone starts.

Book a visit

## Still no hot water? We’ll call you back to book a technician.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

[(647) 692-0819](tel:+16476920819)

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

For AI agents: [site summary](https://assuranceheatingandcoolinghvac.com/llms.txt), [full text](https://assuranceheatingandcoolinghvac.com/llms-full.txt), [sitemap](https://assuranceheatingandcoolinghvac.com/sitemap.xml).
